EGW Trijicon RMR Sight Mount for Ruger Auto

This mount will not work with the optics ready models.

This mount will not work with the RMRcc.

Mounting Hardware is Included

This mount fits:
Ruger MK I
Ruger MK II
Ruger MK III
Ruger MK IV
Ruger P85
Ruger P90-95
Ruger P97
Ruger 22/45

This mount does not fit (including but not limited to):
Ruger 5.7
Ruger P89

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE407C X2 / HE507C / HE507C X2 / HS407C / HS407C X2 / HS507C / HS507C X2, Swampfox Kingslayer / Liberty / Justice

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.