EGW Trijicon RMR Sight Mount for Bomar

EGW Trijicon RMR Sight Mount for photo
$49.99
Availability: Out of stock
SKU: 49512
Barcode: 8600001057724
Brand: EGW
Compatibility: Colt Gold Cup, STI Edge, Springfield TRP Operator
Material: Aluminum 7075
Cookies are disabled in your browser. The website functionality may be broken.

This mount will not work with the optics ready models.

This mount will not work with the RMRcc.

Mounting Hardware is Included

This sight fits (including but not limited to):
STI Edge (either this sight or LPA)
Les Baer 1911 (adjustable rear sights)
Colt Gold Cup Trophy with Bomar Rear Sight Cut
Colt Gold Cup National Match .45acp
Colt Gold Cup National Match 9mm
Springfield TRP Operator
Dan Wesson Bruin (may require fitting due to the Clark cut on the top of the slide)

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Save $20 and get free shipping when you purchase a Holosun Sight with this mounting plate!

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"

Mounting Hardware:
(2) 6-32 Flat Head Screws
(1) 6-48 Torx Head Screw

Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE407C X2 / HE507C / HE507C X2 / HS407C / HS407C X2 / HS507C / HS507C X2, Swampfox Kingslayer / Liberty / Justice

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

 

Leave a comment

Cookies are disabled in your browser. The website is working in a limited mode. To use full website functionality you should enable cookies in your browser.