EGW DeltaPoint Pro Kimber Fixed Sight Mount

Mounting Hardware is Included

This mount fits:
Kimber 1911's with Fixed Rear Sights
Desert Eagle 1911G*
Desert Eagle 1911C*

This mount does not fit:
Kimber Micro
Kimber Micro 9
Kimber Micro 380
Kimber Rapid

The mount is meant to be centered in the slide. The hole for the set screw on this mount is drilled off-center intentionally. This is to allow the set screw to be tightened against the bottom of the dovetail cut in the slide. This creates an upward force on the dovetail of the mount. The set screw is not intended to go in the hole in the slide.

*This mount will require a decent amount of fitting to work with the Desert Eagles and is NOT a drop in part on that application.*

*For this mount to work with the Holosun 407K and 507K, the rear pins on the mount MUST be removed by milling or filing.

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment:
Vortex Defender-CCW 3 MOA Red Dot Sight
Vortex Defender-CCW 6 MOA Red Dot Sight
Bushnell RXS-100 Requires 6-32 x 3/8" SHCS
Bushnell RXC-200 Requires 6-32 x 3/8" SHCS
Bushnell RXU-200 Requires 6-32 x 3/8" Flat Head Screws
Bushnell RXS-250 Requires 6-32 x 3/8" SHCS
Crimson Trace CTS-1500
Holosun 407K*
Holosun 507K*
Holosun EPS-GR*
Holosun EPS-RD*
Holosun EPS-Carry-GR*
Holosun EPS-Carry-RD*
Jpoint
Leupold Delta Point Pro
Optima
Redfield Accelerator
Shield RMS
Shield RMSc
Shield SMS
Sig Romeo Zero
(*with Modification, the rear two locater pins on the plate must be filed off in order to allow the 407K/507K/EPS Models to fit.)

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.