EGW Trijicon RMR Sight Mount for S&W 52

EGW Trijicon RMR Sight Mount for photo
$49.99
Availability: Out of stock
SKU: 49509
Barcode: 8600001057014
Brand: EGW
Color: Matte Black
Compatibility: S&W 52
Material: Aluminum 7075
Cookies are disabled in your browser. The website functionality may be broken.

This mount will not work with the optics ready models.

This mount will not work with the RMRcc.

Mounting Hardware is Included

This mount fits:
Smith & Wesson Model 52

This mount does not fit:
Smith & Wesson Model 4

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE407C X2 / HE507C / HE507C X2 / HS407C / HS407C X2 / HS507C / HS507C X2, Swampfox Kingslayer / Liberty / Justice

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

 

Leave a comment

Cookies are disabled in your browser. The website is working in a limited mode. To use full website functionality you should enable cookies in your browser.