EGW Trijicon RMR Sight Mount for EAA Super Sight

This mount will not work with the optics ready models.

This mount will not work with the RMRcc.

Mounting Hardware is Included

This mount fits:
Elite Stock II with adjustable (LPA/Bomar style, shown above) rear sight
Elite Stock III with adjustable (LPA/Bomar style, shown above) rear sight
Hunter with adjustable (LPA/Bomar style, shown above) rear sight
Limited Custom with adjustable (LPA/Bomar style, shown above) rear sight
Limited Custom Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
Match Elite with adjustable (LPA/Bomar style, shown above) rear sight
Match Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
P Match with adjustable (LPA/Bomar style, shown above) rear sight
P Match Pro with adjustable (LPA/Bomar style, shown above) rear sight
Stock II Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
Stock III Xtreme with adjustable (LPA/Bomar style, shown above) rear sight

This mount does not fit:

EAA / Tanfoglio Witness with Novak style adjustable rear sight, shown above

Save $20 and get free shipping when you purchase a Holosun Sight with this mounting plate!

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE407C X2 / HE507C / HE507C X2 / HS407C / HS407C X2 / HS507C / HS507C X2, Swampfox Kingslayer / Liberty / Justice

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.