EGW Vortex Viper / Venom Colt Gold Cup, Python, Anaconda Sight Mount (fits Burris FastFire and Docter)

EGW Vortex Viper / Venom Colt photo
$49.99
Availability: Out of stock
SKU: 49322
Barcode: 8600001057038
Brand: EGW
Compatibility: Colt *
Material: Aluminum 7075

Mounting Hardware is Included

This mount fits:
Colt Gold Cup
Colt Trooper Mark 3
Colt Python (does NOT fit 2020 and newer models)
Colt Anaconda (does NOT fit 2020 and newer models)*

This is for Colt models with the Elliason style adjustable rear sight.

The elevation screw from the original rear sight is re-used in the center hole on this mount unless you have an Anaconda. An extra screw is available for purchase below as well.

This mount now comes with more material to allow for the front cross hole to be drilled and pinned. We recommend this be completed by a gunsmith.

*Anacondas require a new elevation screw due to the design of the elevation screw supplied with the gun.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Torque Specs: 15 in/lbs

Mounting Hardware:
(2) 6-32 Button Head Screws
(2) 6-32 Flat Head Screws
(1) 6-32 Set Screw

Red Dot Fitment:
Vortex Viper
Vortex Venom
Burris Fast Fire 1, 2, 3, 4
Docter
ADE RD3-001
ADE RD3-002
ADE RD3-009
UTG Reflex Micro Dot
Crimson Trace CTS-1200
Crimson Trace CTS-1300
Sightmark Mini Shot

The mounting screws require a 5/64" wrench and the set screws (when applicable) require a 1/16" wrench.

*All ADE mounts require 6-32 x 3/8" screws.

Please note: We have found that some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. These dots may not fit properly on the posts on the plate. We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins.

 

Leave a comment

Colt
᠁ Colt Python
᠁ Colt Anaconda
᠁ Colt Trooper Mark III
Cookies are disabled in your browser. The website is working in a limited mode. To use full website functionality you should enable cookies in your browser.