EGW HD 30 mm Tactical Aluminum Rings .990"

This product fits:
30mm Tube Scopes

Our bestselling rings are created in our American-made Fadal by machining aircraft grade aluminum from billet one pair of rings at a time.

We bore the holes to 30mm +.0014" When we machine the profiles of the ring we build in a .030" radius on all outside edges. Next we machine a 45 degree bevel around the entire ring and clamp. We clamp the pair on a 30mm mandrill with a 1/8" pin to keep the pair exactly together. We then thread form and tap holes in the ring. Thread forming is 40% stronger than cut threads.

The rings are serial engraved before they are separated. One ring and cap has a decimal in front of the numbers so the caps match exactly. i.e. one ring will show "575" and its identical twin will show ".575".

We then sand blast them for a matte finish and anodize them in Eastern Pennsylvania.

The cross bolt is made from chromoly steel in our turning centers, roll threaded in-house and heat treated and blued locally. The ring nut is beveled on both ends and an inset washer is used to keep the nut from scoring the finish on the clamp. The threads are roll formed for strength, fit (class 2a) and finish. The clamp is machined from billet and complete with radius and bevels, and anodized to the match rings.

EGW Tactical rings use a Fiber Washer so the nut does not mar the finish on the clamp!

Our rings are measured from where the ring sits on the top of the base, to the center of the ring.

Our Tactical rings are available in 3 heights:
.850" LOW
.990" MEDIUM
1.275" HIGH

If your scope has an objective greater than 56mm, we recommended .990" rings or higher.

One set of rings weighs in at approximately 4.8oz.
We recommend that you torque the crossbolts of our HD Rings to 65 inch pounds, and the top screws to 15 inch pounds.
1 Inch machined Delrin Inserts are available and sold separately to accommodate a 1" scope tube.

Material: 6061 Aluminum
Finish: Anodized Matte Black
Crossbolt Torque: 65 in/lbs
Crossbolt Nut Socket Size: 1/2"
Ring Cap Torque: 15 in/lbs
Scope Tube Diameter: 30mm
Ring Height: Medium (.990" from top of picatinny to centerline of scope)