EGW Beavertail Grip Safety SS for .250" Radius (.245" Actual Radius) Series 80

EGW Beavertail Grip Safety SS for photo
$64.99
Availability: Out of stock
SKU: 10701-80
Barcode: 0841370101368
Brand: EGW
Compatibility: 1911
Material: Stainless Steel

Our grip safety will fit the Ruger SR1911 with minimal fitting.

Through our years of experience building guns, we were able to come up with a lot of improvements over the various beavertail offerings available today. Our improvements include the following:

- Our beavertail is wider than the frame @ .770 (allowing you to the blend the beavertail to the frame, and not the other way around)
- The pin hole is reamed to .158 (improving fit and ambi's function)
- Lower bottom grip surface (no need to break into the thumb safety hole)
- Longer bottom (less gap between beavertail and main spring housing)
- Wider bottom to "fill" frame better (around .617)
- Bottom radius smaller to better fill frame radius cuts
- .308-.309 wide to fit frame ears snug (no rattles)
- The pad is fuller and blank allowing for artist's interpretation
- No pits, as the part is machined from bar stock
- Radius is .245 to better fit frames that are pre cut to .250
- Bottom angle better matches main spring housing again for less gap

This beavertail's safety arm is cut to allow for use in Series 80 1911's.
 

  • Machined from: Stainless Steel
  • Finish: Glass Beaded
  • Compatible with: Frames cut for a .245" radius, like STI or Brown
  • Not compatible with: The Wilson beavertail cut. In order to utilize our beavertail grip safety on a Springfield or Caspian frame, you will need to weld the tangs.

Leave a comment